Site Search


Feature Item

Opticut S50
Code: 1411

With the OptiCut S50 you will enter a new level of efficiency. The ability to automatically cut out the defects by simply marking the waste sections. The software will optimise the remaining material for the best solution from your cut list and achieve the highest yield possible. From small pre-finished products up to big, wide and heavy beams, you can cut just one board, or an entire production run of different sizes with absolutely no changeover time or tools. Efficiency and safety for now, and for the future - you can adapt Opticut S50 to your requirements now and retrofit it step by step at any time - into a complete crosscut center


Name: Donna Neil

Ph: +64 9 276 2402
Contact Us

Debarkers | Tenax Debarking System

Code: MA-40-ETenaxDebarkingSystem
Category:  Sawmilling  >  New Equipment  >  Sawmills  >  Log Handling & Processing  >  Debarkers

Tenax Debarking System, providing a smart alternative for high-performance, reliable debarking.  Designed to retrofit any Cambio-style debarker, the Tenax tool system is also standard equipment on new USNR debarkers.

Outstanding Performance – Rugged Durability – Total Value


The innovative design has been fully developed and tested, yielding a debarking tool system that runs rings around the competition. 

PDF: MA-40-ETenaxDebarkingSystema

Enquire Today

Name  *
Company *
Phone *
Email  *
Address  *
Product of Interest 
Comments  *
Please enter the verification code in the image above *