Site Search

Category:
Keyword:

Feature Item

Opticut S50
Code: 1411

With the OptiCut S50 you will enter a new level of efficiency. The ability to automatically cut out the defects by simply marking the waste sections. The software will optimise the remaining material for the best solution from your cut list and achieve the highest yield possible. From small pre-finished products up to big, wide and heavy beams, you can cut just one board, or an entire production run of different sizes with absolutely no changeover time or tools. Efficiency and safety for now, and for the future - you can adapt Opticut S50 to your requirements now and retrofit it step by step at any time - into a complete crosscut center

CONTACT US




Name: John McLachlan
Email:
john@skookum.co.nz

Ph: +64 9 276 2402
Cell: +64 274 932 612
Web:
www.skookum.co.nz
Contact Us

Control Systems | True-Read Grade Mark Recognition System

Code: NM-OP-08-ETrue-ReadGradeMarkReader
Category:  Sawmilling  >  New Equipment  >  Sawmills  >  Scanning & Optimisation  >  Control Systems

Grade Mark Recognition System

Highest accuracy rate in the industry offers lower re-run and off-grade rates.

True-Read Series Overview

 

The True-Read Grade Mark Reader series, consisting of GL and XL models, employs a fully trainable, mill maintainable system that reads and interprets handwritten grade and trim marks, cut-in-two and cut-out marks.

 

Both True-Read GL and XL models recognize marks with 99.7% accuracy under typical conditions (greater accuracy is possible under ideal conditions).

 

 

PDF: NM-OP-08-ETrue-ReadGradeMarkReader


Enquire Today

Name  *
Company *
Phone *
Email  *
Address  *
Product of Interest 
Comments  *
Please enter the verification code in the image above *