Site Search


Feature Item

Weinig Rondamat 934 Profile Grinder
Code: 1422

Circa 1998 Good used condition Manual included "As is, where is" condition


Name: Jonathan McLachlan

Ph: +64 9 276 2402
Cell: +64 276 488 488
Contact Us

General Equipment | Dual Head Saw Guide Resurfacer

Code: MA-35-ESawGuideResurfacer
Category:  Sawmilling  >  New Equipment  >  Sawmills  >  Sawshop Equipment  >  General Equipment

USNR's dual Head Saw Guide Resurfacer is a precision unit designed for accuracy, reliability and efficiency in saw guide resurfacing.

Complete Solution


The USNR Dual Head Saw Guide Resurfacer is a complete stand alone solution.

·        Designed to accurately machine both Babbitt pads of a center saw guide in a single pass.

·        Also able to machine the single Babbitt pad of end saw guides

·        Efficient operation easily achieves the accuracy needed for thin kerf saw guides




We’ve been designing and installing saw guides and kerf reduction technologies since 1934 and we’ve learned a lot about the fine points in the process.  Now we’ve poured all that knowledge and experience into the development of a superior saw guide resurfacing unit.




·         This is a precision machine designed to maintain the critical accuracy required to guide thin kerf saws and cut lumber within close tolerances

·         It’s capable of machining double sided saw guide babitt pads in one pass, for an efficient use of operator time




·         Can be used for single sided or double sided saw guides

·         Can accurately resurface many types of saw guides




·         Electrical cutter head drive motors – 120VAC-60Hz draw about 11 amps under each load

·         Pneumatic air supplied by mill should be clean and dry at 2.5 scfm with 85 psi minimum supply pressure




PDF: MA-35-ESawGuideResurfacer

Enquire Today

Name  *
Company *
Phone *
Email  *
Address  *
Product of Interest 
Comments  *
Please enter the verification code in the image above *