Site Search

Category:
Keyword:

Feature Item

Opticut S50
Code: 1411

With the OptiCut S50 you will enter a new level of efficiency. The ability to automatically cut out the defects by simply marking the waste sections. The software will optimise the remaining material for the best solution from your cut list and achieve the highest yield possible. From small pre-finished products up to big, wide and heavy beams, you can cut just one board, or an entire production run of different sizes with absolutely no changeover time or tools. Efficiency and safety for now, and for the future - you can adapt Opticut S50 to your requirements now and retrofit it step by step at any time - into a complete crosscut center

CONTACT US




Name: John McLachlan
Email:
john@skookum.co.nz

Ph: +64 9 276 2402
Cell: +64 274 932 612
Web:
www.skookum.co.nz
Contact Us

Tilthoists & Infeeds | 6 Tonne Tilt Hoist

Code: 1408
Category:  Sawmilling  >  Used Equipment  >  Planermill  >  Tilthoists & Infeeds

Please find attached photos of our 6 Tonne Tilt Hoist.
Pack Height - 1.2
Pack Width - 1.2
Pack Length - 6.1

New Electrics Unit
New Fillet removal belt.

PDF: Image_1408_-_6_Tonne_Tilt_Hoist-95393


Enquire Today

Name  *
Company *
Phone *
Email  *
Address  *
Product of Interest 
Comments  *
Please enter the verification code in the image above *